How to Install Precision Works Camber Bolt Kit on Nissan
By Aftermarket Car Parts -Private Label Mfg | Published: 2026-10-25
Category: How-to Guides
Step-by-step instructions for installing a Precision Works camber bolt kit on Nissan Titan, Pathfinder, Frontier, and other models. Get proper alignment after a lift or drop.
Quick answer
Install a Precision Works camber bolt kit on your Nissan Titan, Pathfinder, Frontier, or Xterra by replacing the factory upper control arm bolts with the included eccentric bolts, then adjusting camber to spec before tightening to torque.
Why you need camber bolts after lifting or lowering
When you lift or lower a Nissan truck or SUV, the suspension geometry changes and the factory alignment range may no longer be enough to bring camber back into spec. The Precision Works camber bolt kit gives you extra adjustment range so your tires wear evenly and the vehicle handles correctly.
This kit fits many Nissan models from 2004 onward, including Titan, Pathfinder, Frontier, Xterra, Armada, and the Infiniti QX56/QX80. It also works on the Suzuki Equator. Always confirm your vehicle is on the fitment list before starting.
Tools and safety prep
You will need a floor jack, jack stands, a lug wrench, a socket set (typically 18mm and 21mm), a torque wrench, and a marker or grease pencil. Work on level ground and always support the vehicle with jack stands—never rely on the jack alone.
A common mistake is skipping the alignment check after installation. The bolts allow adjustment, but you still need a professional alignment to set camber to the correct angle for your specific ride height.
Installation steps
- Step 1: Lift and secure the vehicle: Park on level ground, loosen the lug nuts on both front wheels, then jack up the front of the vehicle and place jack stands under the frame rails. Remove the wheels. Never work under a vehicle supported only by a jack.
- Step 2: Remove the factory upper control arm bolts: Locate the two bolts that attach the upper control arm to the steering knuckle. Use a socket and breaker bar to remove them. On some models, you may need to support the lower control arm with a jack to relieve tension. If the bolts are seized, apply penetrating oil and let it soak for 10 minutes before trying again.
- Step 3: Install the Precision Works camber bolts: Insert the eccentric camber bolts through the upper control arm and knuckle in the same orientation as the factory bolts. Hand-tighten the nuts so the bolts are snug but still allow the control arm to pivot. Make sure the eccentric washer is positioned so you can see the alignment marks—this is how you will adjust camber later.
- Step 4: Adjust camber to the desired setting: Rotate the eccentric bolt to move the knuckle in or out. Use a camber gauge or take the vehicle to an alignment shop to set the angle to factory spec or your target value. Tighten the nut to the manufacturer's torque spec (typically 80-100 ft-lbs). A common mistake is tightening before adjusting—always set the angle first, then torque.
- Step 5: Reinstall wheels and lower the vehicle: Put the wheels back on, tighten the lug nuts in a star pattern, lower the vehicle, and torque the lug nuts to spec. Drive a short distance and recheck the alignment if possible. After a few miles, re-torque the camber bolts to ensure they haven't loosened.
Product facts
- Precision Works Camber Bolt Kit for Nissan Titan Pathfinder Frontier: Precision Works Camber Toe Kit fits 2004-2015 Nissan Titan, 2005-2019 Frontier, 2004-2012 Pathfinder, and many other Nissan/Infiniti models. One kit covers multiple popular Nissan trucks and SUVs, so you can correct alignment after a lift or drop without buying vehicle-specific parts.
Precision Works Camber Bolt Kit for Nissan Titan Pathfinder Frontier
