PLM 산소 센서 번 클램프 - 용접 불필요 디자인

I was a little skeptical about the clamp holding up under heat, but after a few hard runs it hasn't budged an inch. The no-weld design saved me a trip to the fabricator and feels surprisingly solid.

Finally, a clean way to add an O2 sensor without welding—the clamp design held tight on my test pipe with no leaks. I had it installed and snug in under fifteen minutes, which beat borrowing a welder.

Took me maybe 10 minutes to get it positioned and tightened on the pipe, and the clamp holds the bung rock solid without any welding. Such a clean solution for adding a wideband sensor to a stainless system.